Generator YAW Mounts for any 4" diameter motor bodies.
No Longer Manufactured

Here are a couple of mounts for your generator project to save you a bunch of time and headaches.  
 Just simply set your 4" diameter generator in the mount that is designed for your DCPM motor and tighten the 2 nuts down evenly to hold it in place.  Make a quick Vane (tail) or buy one of my vanes, then set it over the top of any standard 1 1/2" pipe. 

A locking collar on the bottom or another piece of pipe is required to keep it from sliding on down the pipe, and one on top is recommended to make sure it does not come off in a storm.

GM-3040

For 4" diameter 5" to 6" long DC PM motors

Motor shown is NOT included.

Specifications:

For any 4" DC PM motor up to 6" long.
(Example: Ametek 30, 40, 50 short body)

1 1/2" standard pipe mounting (locking collars required)

Wires run down center of pipe
(no slip ring required)

Weighs 7 pounds

GM-5072

For 4" diameter 7" long body DC PM motors

Specifications:

For any 4" DC PM motor with up to 7" long body.
(Example: Ametek 40, 50, 60, 72 mid-length body)

1 1/2" standard pipe mounting (locking collars required)

Wires run down center of pipe
(no slip ring required)

Weighs 8 pounds

GM-BOSS99

For 4" diameter 9" long DC PM motors

Motor shown is NOT included.

The hammer shown is a small ball peen hammer to show that this mount will also balance very easy.

Specifications:

For any 4" DC PM motor up to 9" long body.
(Example: Ametek 99 long body)

1 1/2" standard pipe mounting (locking collars required)

Wires run down center of pipe
(no slip ring required)

Weighs 9.25 pounds

See my Vanes.

Return to Parts

Return to Instructions

Home